I purchased this part and my machine is still not working properly. The machine is pumping the water out....the machine is not going thru the high speed spin, therfore the clothes are not coming out of the machine with water on them. The are soaked. What else do I need in addition to this part?
ANSWER Robert, are you sure the washer is spinning at all ? The place to start, with a complaint like yours are the off balnace switch circuit and the spin enable switch on the door latch assembly. If you have a broken wire or inoperable off balance switch, the tub will starty to spin , stop and rock back and forth, to redistribute the load. If the spin enable switch does not have a closed circuit, once the door has closed and locked, it will not spin at all. You can test the off balance and spin enable switch circuits up at the washer main control board, located in the front right corner of the dryer cabinet, or at the multiplugs located on the sides of the tub assembly located under the front top trim panel on the washer with a multimeter. Thanks and Good Luck
Answered by AppliancePartsPros.com | Wednesday, December 14, 2011