Washer works great untill it hits the spin cycle, tries a couple of spins then stops giving a code uC, which leads me to the wet clothes of trouble shooting. Will not perform quick spin test with- out giving uC code. Which then leads me to the tube displacement sensor. There is no access panel on back and can't figure out how to get the top up to check for loose or broken wires. Then I get on line and eveything seems to point to the drain pump. How to I open the cabinet up to check for the simple things first i.e. brooken or loose wire? Hate to buy new drain pump and its the tub displacement sensor, ect..... Any suggestions. Multiple questions, I know, thank you.
ANSWER Hello Larry,
To get the top up on the unit you would use a putty knife inbetween the cabinet and main top and depress clip on either side. This will release the main top and you can lift it. To remove the front panel there will be 2 - 5/16" hex screws holding front panel in place.
Answered by AppliancePartsPros.com | Monday, December 31, 2012