I bought a new pump for the top unit and installed it ran 1 load of dishes in each draw unit and now both units have a continuous running sound with nothing happening. i had to turn off the breaker to shut them down last pm or they both would have run last night. Is there a master programming sequence to reset them?
Edward Y. for Model Number kudd01dsss
ANSWER Hello Edward. Unplug dishwasher or disconnect power for
10 seconds to reset. If issue continues, FLOOD SWITCH ACTIVATED. Lid Not Sealing Correctly
1. Unplug dishwasher or disconnect power.
2. Remove lid and repair or replace lid or
motor assembly. Water Valve Leaking
1. Unplug dishwasher or disconnect power.
2. Tighten connections or replace valve as
necessary. Spray Arm Is Split
Replace spray arm. Spray Arm Not Turning Freely
Clear any obstructions to spray arm. Split Inlet Hose
Replace inlet hose. Split Drain Hose
Replace drain hose. Blocked Drain Hose
Clear hose blockage. Heater Plate O-Ring Leaks
1. Unplug dishwasher or disconnect power.
2. Replace o-rings on heater plate. Moisture / Foreign Matter On Chassis Board
Flood Switch PCB
1. Unplug dishwasher or disconnect power.
2. Clean chassis PC board and flood switch
area. Power Failure To Lower Tub Causes Flood
Error Code On Top Tub
1. Unplug dishwasher or disconnect power.
2. Replace chassis PC board.
Answered by AppliancePartsPros.com | Friday, December 28, 2012