Stared washer on speed cycle 1/2 way thru the wash, after the first spin cycle the washer stops and display F6 error code. I test tested the motor and have 7 ohm at each terminal. Tested the techometer I have 125 ohm. The wire harness is good. Is there anyway of checking the MCU. Or can you suggest any other solution.
ANSWER Vic, The F6 error code on your unit indicates a communication error between the MCU 8182706 on the base of the washer cabinet and the CCU 8182689 attached to the top of the cabinet, under the top panel. Check and make sure there are no loose wire connections between the motor and MCU and the MCU and the CCU. The issue is most likely in the MCU, but when you remove the the lower front access panel you'll find the Tech Data Information Sheet, and can conduct the diagnostic and motor tests to verify. Thanks
Answered by AppliancePartsPros.com | Monday, September 17, 2012