My dryer was working, made a popping sound then stopped. Researched on here and did the following. Checked te thermistor and it read properly, checked the fuse and it had continuity. Did a diagnostic and got the f25 code which I was told was the inlet thermistor. I purchased that from this site, installed it, plugged in the dryer, pushed power then start and all I get is a click, a beep and the sensor light like before. What else can this be what else can I check?
thanks
Jeff
Jeff for Model Number wed6200swo
ANSWER Hello Jeff,
The F25 does indicate that the inlet thermistor or wiring has short in it. Since you just replaced the inlet thermistor then you will want to check the wiring to make sure that it is good. Do this test. Remove wires from thermostat and plug dryer in. Rund diagnostic test and if the F25 or F24 is not an error that is displaced the wires are good. If the unit still shows f 25 or f24 then the wires are bad. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html
Answered by AppliancePartsPros.com | Thursday, January 24, 2013