Is the AP3965135 the control board for this dryer? Does this need to be replaced if you get a "F-01" code? Is it located in the control panel?
Brian for Model Number medz600tw1
ANSWER Brian, You're on the right track, the "F-01" code dos indicate an issue with the primary control board "“F-01” flashes when there is a primary control failure. Replace the machine control electronics." W10111606 is the control board you will need. It is located on the the left side interior of the cabinet, under the top. heres some information " 1. Unplug dryer or disconnect power. 2. Turn off gas supply to dryer. 3. Remove the rear screws from the top cover of the dryer. 4. Lift the rear of the cover, pull back, and remove the cover from the dryer. 5. Remove the front machine control electronics (MCE) bracket screw.6. Remove the screw from the MCE, unhook the tabs from the bracket, and remove the electronics. 7. Disconnect the wire connectors from the MCE board at P8, P9, P13, P14, and the black and red wires from relay K2.(you might find it easier to label the connections as well). Good Luck and Thanks
Answered by AppliancePartsPros.com | Tuesday, November 08, 2011