How to install element?
ANSWER Hello James, here are your instructions. 1. Turn off the electrical supply going to the range. 2. Open the oven door. 3. Remove the two cooktop bracket screws from the bottom front of the cooktop. 4. Pull the cooktop forward far enough to unhook it from the top of the range. 5. Lift the front of the cooktop and rest it against the control panel. CAUTION: Be careful that the cooktop does not accidentally fall forward. 6. To remove an element, a) Remove the wires from the element and limiter terminals. b) Remove the element bracket screw (shown above) for the element and limiter you are servicing. c) If you are removing the center element and limiter, remove the screw from the hot surface indicator bracket and remove the indicator. d) Carefully lift the bottom of the bracket just far enough to remove the element. NOTE: If you are removing an element at the top of the bracket, remove the lower element first, lay it on top of the range, and then remove the top element
from the bracket. REASSEMBLY NOTE: When you reinstall the element and limiter, make sure that the alignment pins are inserted into the correct bracket slots, (see the photo to the right) then reinstall the bracket screw to secure it to the cooktop. Hope this helps!
Answered by AppliancePartsPros.com | Thursday, December 13, 2012