24/7 Customer Support

:

Customer Questions and Answers for F125 Boost Thermostat by Whirlpool

  1. Our Price $18.56
    Compare At $24.00
    You Save $5.44
    • Part Number: AP4114577
    • MFG Part Number: 99001005
    • Made by: Whirlpool
    Add to Cart

Questions & Answers

For Whirlpool F125 Boost Thermostat (Part Number: AP4114577)

Answer or Comment

View all Questions

Maytag dishwasher runs fine with Temp Boost Sensor Off. With the Temp Boost Sensor On, the wash cycle progresses normally until it gets to the point where the Heat Delay light comes on. Instead of a short delay and continuing on with the cycle it gets stuck, continues to run, but never progresses to the end of the cycle. The water gets super hot. I'm guessing the F125 Boost Thermostat is bad. Please confirm. I see where the thermostat is located in behind the lower panel below the door. Can you give some instruction of how to access it. Thanks

Mark for Model Number DWU8750BAB

ANSWER Mark, When you take the lower access panel off, on the right side of unit is where the thermostat would be located. Make sure that power is turned off to unit when replacing. It is held in by a clip that just clips to the tub. Remove clip, take wire off thermostat and put new thermostat in the clip and reconnect wires and clip back in original position. 

Answered by AppliancePartsPros.com   |   Thursday, April 04, 2013

We are Safe, Secure, Dependable and Trusted
  • BizRate.com Customer Certified Site - Click to Verify