I ordered the front bearing and seal, Part No 3406129 and read the directions which came with the parts.. It came with 3 clips and the instructions under item 7 said to "make sure the three holes in the bearing fit over the the plastic clips". The problem is the felt bearing and seal had only 2 holes. The original mount on the existing washer has three clips and the old seal had three holes.
Is this a manufacturing defect?
ANSWER Hello Michaell. No, most likely, you will need to remove the felt stuck in the pre cut hole. Sometimes it does not get pressed out all the way.
Answered by AppliancePartsPros.com | Saturday, February 23, 2013