24/7 Customer Support

CHECKOUT
Items in Cart:
Total
$0.00

Customer Questions and Answers for Heating Element by Whirlpool

  1. Our Price $35.82
    Compare At $44.48
    You Save $8.66
     Watch Video
    • Part Number: AP4511544
    • MFG Part Number: W10082892
    • Made by: Whirlpool
    Add to Cart

Questions & Answers

For Whirlpool Heating Element (Part Number: AP4511544)

Answer or Comment

View all Questions

washer quit after starting now gives a blinking green light 7 blinks & pause book says check heater element. i need how to instructions hope you can help thank you & merry christmas

Wayne L for Model Number kenmore model 66517283400

ANSWER Wayne, First, you want to make sure you have a hot water temperature of 120 dgrs F. to the dishwasher on the first fill of the cycle, you select. You want to perform the "diagnostics cycle" to reset the control board. "Pressing the following option keys in the sequence shown will either start the Diagnostics Cycle or turn on the Rapid Advance feature for stepping through customer selectable cycles: HIGH TEMP SCRUB, AIR DRY, HIGH TEMP SCRUB, AIR DRY Or SANI RINSE, AIR DRY, SANI RINSE, AIR DRY ** (Note: HIGH TEMP SCRUB = POWER SCOUR = HIGH TEMP SCOUR) (Note: AIR DRY = NO HEAT DRY = ENERGY SAVER DRY)** Once the diagnostic test has completed. Start a normal wash cycle, without detergent and dishes, and allow the dishwasher to run tghe complete cycle, this will reset the sensor system, and you should be fine from there on, as long as you're sure the hot water temp. is 120 dgrs at the start of the cycle. Thanks and Good Luck 

Answered by AppliancePartsPros.com   |   Thursday, December 22, 2011

We are Safe, Secure, Dependable and Trusted
  • BizRate.com Customer Certified Site - Click to Verify