hello i have video about tapping coupler but does not come loose ? anything else maybe ?
ANSWER Russ, The other method, is a bit "dicey", slip the end of a flat blade screwdriver under the outer lip of the coupling, " With the blender facing you, insert a flat blade screw driver between the black drive coupler and the blender housing: approximately 1/2 inch. Raise up on the screw driver; this will bend the drive coupler up . Turn the coupler approximately 1/4 turn and repeat raising the screw driver higher each time. Continue this until the coupler comes off the motor shaft. This is usually accomplished in 3 or 4 attempts." You have to be careful and try and limit the damage to the housing. Hope this will work for you, otherwise, you'll need to remove the base, hold the motor shaft,so it doesn't turn and remove the coupler from the shaft. Thanks and Good Luck
Answered by AppliancePartsPros.com | Tuesday, March 27, 2012