clothes do not wring out well, they are not dripping wet but do seem soaked i have replaced belt,pully,and spring.
i do see a gap between brake pads and caliper.
did not see anything in pump when i had it out.
i did use a shop vac to suck out drain line and pump and feed drain for wash tub. they are all clear.water drains from wash tub and helix disengages brakes motor seems like it goes in a 450 to 500 rpm speed but does not go into a 710 rpm motor does not run hot and does not smell. also i had wife do a light load of clothes, same problem.re:one forth the wash tub of clothes
no noises or screeches or knocking. i did clean both pullies b/4 replacing belt too
ANSWER Dave, Did you also check, clean and lubricate the idler pulley and assembly, and adjust the idler spring tension ? You'll also need to remove and check the brake pads R0000014 for cracks, warpage or excessive wear, indicating the brake pulley R9900474 may be "dragging" due to worn out "fingers" on the plate, or worn washers between the drive pulley 40047102 and brake pulley.
Answered by AppliancePartsPros.com | Thursday, May 02, 2013