24/7 Customer Support

CHECKOUT
Items in Cart:
Total
$0.00

Customer Questions and Answers for Mounting Stem Repair Kit by Whirlpool

  1. Our Price $52.79
    Compare At $85.02
    You Save $32.23
     Watch Video
    • Part Number: AP4390013
    • MFG Part Number: 6-2095720
    • Made by: Whirlpool
    Add to Cart

Questions & Answers

For Whirlpool Mounting Stem Repair Kit (Part Number: AP4390013)

Answer or Comment

View all Questions

What is required to install the mounting stem repair kit? Should the bearing also be replaced? How is this done?

Jim for Model Number Maytag A612

ANSWER Hello Jim. You will need to replace both the bearing and stem kit. Here are most of the basics. Once you have the front panel removed and the top raised up and agaist the wall(of course you've already unplugged the power cord and turned the water faucets off). Remove the tub cover There are 8 tabs along the outer paotion of the outer tub, prees down on the tub cover and "unsnap" the retainer tabs, and remove the cover. remove the agitator. loosen, but don't remove the 1/4 in. haex head screw in the lower portion of the agitator barrel, and lift the agitator out. Using the spanner wrench and hammer loosen and remove the clamping nut( this is a left handed thread, so it must be turned clockwise, be careful with the hammer, don't chip the porcelain spin tub, then lift the spin tub out of the outer tub. Using an allen wrench or #25 "torx" remove the set screw from the mounting stem assembly(the set screw is located in the indentations for the spanner wrench). This is also a left handed thread and will unscrew in a clockwise direction. Once the stem is removedremove any remaining seal, clips and washer from the area. Disconnect the tub to pump hose from the bottom tub outlet. Using a 1/2 in socket and a boxxed end 1/2 in. wrenck loosen and remove the three tub mounting bolts which hold the outer tub to the support legs. Grasp the tub and lift it up and rest it on the transmission shaft and disconnect the air dome hose from the tub right rear corner area and set the tub on the floor. step on and push the bearing assembly out the bottom of the tub, flip the tub over and insert the new bearing assembly into the bottom of the tub, use slight pressure ans seat the bearing in the tub opening. Check and remove the sinterred bearing race( if it remained stuuck on the transmission housing) clean the area with sandpaper and lubricate with high speed oil(turbine oil 55977) or an equivalent. and reverse the procedure, Before you install the mounting stem, put a few(3 or 4) drops of oil inside the bearing assembly, then complete the install of the stem and tubs. Before you complete the repair. start the washer and run it in the final spin cycle for at least 5 minutes to seat the bearing and the seal, then start the washer and check for leaks( you may also want to add detergent to the water to help wash out the tub and interior of any grease, oil,etc. If all goes well it should take somewhere around one hour to repair and test the washer. 

Answered by AppliancePartsPros.com   |   Friday, October 04, 2013

We are Safe, Secure, Dependable and Trusted
  • BizRate.com Customer Certified Site - Click to Verify