Got this new oven door trim kit and I would like instruction or some type of diagram on how to install the trim on the door.
ANSWER Nancy, Here are the basic instructions for working on the trim and oven door glass " 1. Turn off the electrical supply to the range.
2. Remove the oven door and position it on a protected floor with the handle and outer door glass facing up. 3. Raise the top of the door and remove the two screws that secure the top of the door trim and the handle to the door liner, then remove the handle and top trim.
4. Slide the outer door glass out of the bottom trim channel and install the new glass in its place. 5. Install the top trim and handle on the oven door and secure them in place with their two mounting screws. REASSEMBLY NOTE: The side trim on Whirlpool oven doors fits under
the top edge of the outer door glass, and the side trim on Roper models fits over the top edge of the glass. Make sure that the trim is
seated properly when you tighten the screws .6. Reinstall the oven door on the range." *** NOTE The new trim kit side rails will have plastic divots on the end, These divots will fit into the two farthest out screw holes in the bottom trim strip, and you will not use the two screws that mounted the original side trims to the bottom trim *** Thanks and Good Luck
Answered by AppliancePartsPros.com | Tuesday, November 29, 2011