Ever since a recent power outage my Kenmore oven 665.95179300 will not heat up. The display says "Preheat" but neither the main oven or the lower warming drawer will heat. Retrieved error code E0 F3 and then tested the sensor. It reads 1.083 K Ohms, which is within spec I believe (1083 Ohms). The sensor leads go to a 6-pin plug. Any advice on next step to test for the problem?
ANSWER Derecho,Are you sure you have 220-240 Volts across the two outised ternminals of the terminal blocks and 120 VAC from each outside terminal to the center terminal. Then disconnect the P3 connector at the clock, and check the sensor resistance across pin 5 and 6 (two purple wires) for the same resistance, That will confirm if the sensor and the wires are intact and informing the control coprrecly. It sounds like you've lost the L1(black) power supply to both ovens, due to a damaged wire or control.
Answered by AppliancePartsPros.com | Thursday, July 12, 2012