Apparently this is the substitute replacement for motor/pump assembly for my old kenmore ultra wash. This motor/pump replacement came with an relay which I'm not sure what it is for and where to put it and use it with wiring. (i.e I don't see any wires or jumpers). I'm totally in the dark on this as this motor/pump configuration did not come with instructions or wiring diagram. I was just assuming that it was an extra part for perhaps a different washer ?
ANSWER Hello Richard,
This pump replaces several models. If you unit attached to the wire harness and does not have the relay then it was meant for one of the other units.
Answered by AppliancePartsPros.com | Tuesday, November 13, 2012