I have a Kenmore Elite washer MN 110.27072602, after the wash cycle the pumps kicks in and drains the water out but stays running even though there is no water left. The machine can not start the spin cycle due to the pump is still engaged. Tried a new Electronic control board and replaced the vacuum hose that runs to the Electronic control board. Any suggestions would be helpful.
ANSWER Hello Bill,
You may want to check all your connections from pump to control board. Ensure that there is not debris in the air dome hose from control to tub. If these check ok then you will need to replace wire harness kit W10183157.
Answered by AppliancePartsPros.com | Friday, November 09, 2012