24/7 Customer Support

CHECKOUT
Items in Cart:
Total
$0.00

Customer Questions and Answers for Sensor by Whirlpool

  1. Our Price $40.21
    Compare At $47.85
    You Save $7.64
     
    • Part Number: AP5669052
    • MFG Part Number: W10548509
    • Made by: Whirlpool
    Add to Cart

Questions & Answers

For Whirlpool Sensor (Part Number: AP5669052)

Answer or Comment

View all Questions

Note: This question is for the older version of this part, but we thought you might still find it helpful

My ice maker was working fine but full of mold. I removed the water pan, pump, and ice cutter. Cleaned everything and put it back together. During the fill cycle the water comes on for 10 seconds then shuts off. It is not enough water for the circulating pump to move water over the evaporator. If I manually fill the pan it circulates fine and creates ice. I thought the water level sensor was bad so I went into diagnostic mode, tested it, and it was able to tell when water touched it. Then I set the ice level to thick and turned it back on. The first cycle produced ice as normal, but the second cycle had the same issue of not filling the pan enough. What could this be? The water level switch or perhaps the control board?

Jason J for Model Number GI15NDXTB0

ANSWER Jason, This issue would most likely be caused by the water level sensor. Even though it tested good during the test mode the sensor may be malfunctioning when in use. 

Answered by AppliancePartsPros.com   |   Monday, May 13, 2013

We are Safe, Secure, Dependable and Trusted
  • BizRate.com Customer Certified Site - Click to Verify