My washer fills with water then stops (doesn't agitate or drain). It will spin, after I manually drain the water. Therefore, I need instruction's on how to check this Sensor Switch (AP4501024) for Continuity/Ohm's and Voltage?
ANSWER Gizmo, The only available check , at this time is, 120 VAC on the Blue/Orange wire at the load sense switch in a fill /wash cycle. We have no resistance or continuity checks at this time. If you have no clogs, kinks or twists in the air tube from the sensor switch to the connector on the right rear of the tub, and you have voltage into the switch, you'll need to replace the switch. Thanks and Good Luck
Answered by AppliancePartsPros.com | Friday, November 25, 2011