Note: This question is for the older version of this part, but we thought you might still find it helpful
The dryer stops working and I can unplug the cord and wait a few minutes and it will start back up. A tech said it was the main power board but I replaced it and it does the same thing. I put the original one back in. I was checking the continuity of the cord and then from the block to the board. When I check the ground or the power on the power on the right I am getting some continuity across those 2 terminals. When the dryer is running it is acting erratic ie end of cycle buzzer going off continuiously. Will the bleeding across the block cause this?
ANSWER Hello Fred,
You will want to check to make sure that your motor is good. The cycle buzzer is in the main board but gets signal from the motor. Check the windings to make sure that you dont have a winding shorting out. Check from terminal 4 to ground, terminals 4 to 5 and terminals 4 to 6.
Answered by AppliancePartsPros.com | Friday, January 18, 2013