Dishwasher quit working and clean light blinking.Opened up dishwasher and found small leak at heater element that had shorted and burned the red power wire and terminal. Replaced red wire and terminal and complete heater element. Reinstalled unit and clean light still blinking.What next?
ANSWER Hello Ben,
You will want to run a diagnostic cycle. This should allow unit to run normal again. If not then you have a bad control board. To start service diagnostic cycle you will press the following keys within 6 seconds. Heated dry, Normal, Heated Dry Normal.
Answered by AppliancePartsPros.com | Wednesday, February 06, 2013