Recieved the thermal Dryer cut off kit # ap3094244. it looks a little different as it does not have the plug for the two red wire harness that went on the old part, # 8577891.. there was also a new part that I placed on the upper setion ot the heating duct. Pugged it in and nothing happened. When pressing the start button, the sensing light on the panel lights up and nothing else happens. While I was out here on the pc, the dryer signaled it was done, and beeped. It was not runing an must have timed out?
Anyway, I found the diagnostic sheet and managed to pull some codes: F-23, F-25 and C-5. Checked the Exhaust Thermister, no resistance, same with the Inlet Thermister. Very strange. Checked the P4-3 and P4-6 terminals and the reading was 13.8k Ohms. This tells me to replace the Machine Control Electronics.
What is the next step? Help. Tired of going to the laundrymat.
ANSWER Hello Peter. If the tech sheet is referring you to replace the control board, then that is what you will need to do with the unit.This is provided to help the technician repair the units.
Answered by AppliancePartsPros.com | Friday, February 15, 2013