Just bought new tranny due to no-agitation on the old one. After install of new tranny I have great agitation, but no spin. Any ideas??
ANSWER Paul, did you replace the tub bearing as well ? If so did you have difficulty installing the outer tub over the transmission sleeve ? Did you overtighten the mounting stem, it only needs to be hand tight then a couple of taps with a hammer to tighten. Check and make sure the tub cover is nor seated too low, and holding the tub in position, there should be a 3/8 to 5/8 inch gap between the two components.Then check and make sure you have the transmission drive pulley installed properly and the drive lug is properly adjusted. We'll send you some information that may help you re check everything. Thanks
Answered by AppliancePartsPros.com | Wednesday, August 01, 2012