Oven wont work or control panel after cleaning. How can I ck the transformer? What is the output voltage? Thermal fuse is good and got pwr to the control board but nothing to the door lock switch or the control panel.
ANSWER Hi Rob. There is a supplied wiring diagram in behind the storage drawer or the rear control panel . The red and white incoming to the transformer will be 120 vac. You need to check the transformer rating plate and see what output voltage should be (ex. 24 vac or... ).TEST PROCEDURE Refer to page 2-4 for the procedure for servicing the control power and lamp transformers. 1. Disconnect power from the range. 2. Set the ohmmeter to the R X 1 scale. 3. Disconnect the wires from the transformer’s terminals. 4. Touch the test leads to the transformer LINE (primary) terminals. The ohmmeter should indicate 40 to 45 O. 5. Touch the test leads to the transformer LOAD (secondary) terminals. The ohmmeter should indicate less than 1 O. Transformer part # W10111628. There is a control board under the unit at the center . Remove the cover and see if there is an issue there. Board part # W10181438. Make sure the supply wires are tight at the terminal block. Thank You.
Answered by AppliancePartsPros.com | Thursday, January 26, 2012