We have a whirlpool cabrio washer. When it starts it cycle it dumps water in a few seconds then it starts humming and hums for a couple of minutes and it never done this before. Let it go longer and it goes thru a normal wash cycle. Is this the electronic board or is it the water valve sticking because of hard water. I ohm tested all the coils and they read 820 ohms each except the one that doesn[t have a coil on it.
ANSWER Solomon, Start at the fill valve W10364988, also check and flush the water faucets, and repalce hose screens and washers 12001413 and Y013783. Based on your post, the solemoid is remaining active, but the plunger or diaphram is failing and the water does not enter the tub.
Answered by AppliancePartsPros.com | Friday, December 28, 2012