24/7 Customer Support

:

Customer Questions and Answers for Wash Motor by Whirlpool

  1. Our Price $209.16
    Compare At $248.90
    You Save $39.74
    • Part Number: AP4365135
    • MFG Part Number: 6-919922
    • Made by: Whirlpool
    Add to Cart

Questions & Answers

For Whirlpool Wash Motor (Part Number: AP4365135)

Answer or Comment

View all Questions

After my dishwasher fills, the unit stops and does nothing else. No motor sound, no spinning of spray arms, nothing until I hit cancel. Then it drains. Serial #13034334AV. Its a Maytag Quiet Series 100.

Will for Model Number MDB5600AWW

ANSWER Hello Will, This sounds like you either have a bad winding in the motor or a bad control. Disconnect the unit from the power supply for the first tests you need to make. This is fairly easy to pin down. Remove the kick panel and unplug the motor. Using your test meter set to resistance, test from the terminal the green wire connected to to the other three terminals. None of these should read open or zero. There should be a resistance reading there, but through 45 minutes of researching I could not locate the exact resistance of the motor windings. If any of the readings are zero or open, the motor is bad. If you get a resistance reading on all three, you need to go to the next test. The next test is for voltage. First, remember to reestablish thew power supply. Fill the unit with water so if it were working properly the motor would start. Now with your test meter set to ac voltage, test from ground to the blue wire. This is the power supply from the control board. If there is voltage there, the start capacitor or the wiring harness have an issue. If there is no voltage from ground to the blue wire, the control board has failed. 

Answered by AppliancePartsPros.com   |   Friday, June 15, 2012

We are Safe, Secure, Dependable and Trusted
  • BizRate.com Customer Certified Site - Click to Verify