Trash Compactor Panel Parts

Toe kick panel for trash compactors. Installs at the base of the unit to cover the bottom gap. Replace if cracked, dented, discolored, or missing.

Complete door assembly for your compactor. Replaces cracked, dented, or damaged door panels. Restores the exterior appearance and proper closure.

Replacement front panel frame for compactors. Restores exterior appearance and secures the control area. Direct-fit trim piece for damaged, cracked, or faded frames.

This complete Door assembly II replaces a damaged or worn refrigerator door to restore fit, seal and appearance. It provides the full door panel and mounting points so the door closes properly and protects cooled compartments. What it does

• Replaces a cracked, dented or misshapen door panel that prevents proper sealing
• Restores door alignment and hinge mounting for smooth opening and closing
• Re-establishes the barrier that helps maintain internal temperature and energy efficiency
• Provides factory mounting surfaces for bins, trim and gasket to secure interior storage

• Disconnect power and remove food and shelves from the door area before starting
• This is a large component; two people and basic hand tools are usually required for safe handling and installation
• Support the door while removing hinge hardware to avoid dropping or bending
• After installation, check door alignment and gasket seating; allow time for the door to settle before final adjustments