bought these buttons for my dishwasher, can't figure out how to put them in... any advice?
Answer Dave, You didn't include the model number of your unit. In most cases you will need to dismantle the control panel and control module. here's some basic, general help: " Disconnect wire harnesses from module after noting connector locations. ??Remove fascia panel from console by removing four (4) T-20 Torx screws.??Remove two (2) T-20 Torx screws holding module to console.??Carefully pry back locking tabs on each front corner of module, then remove module from console. Remove button pad from module." Thanks and Good Luck