I'm unable to find parts or other information for this model on your website. I'm getting an error code of E24. I have checked all the drain stuff and it washes dishes and drains normally when I run the customer service program.
Answer Hello Duke,
You should remove the filters and the screw holding the drain pump cover in position. Check in the impeller area for any debris. This is a very common problem with these units. The method I use to check this area is a wet vac. This keeps you fingers from getting cut if any small glass shards are in this area and will easily remove them. Just use a small screwdriver to turn the impeller a bit while using the wet vac so it can remove anything in the area. The impeller can also be missing vanes or the impeller can be separated from the drain pump
00611332 motor shaft and only pumps out part time. The control could have an issue also if the drain pump checks out good. Since the unit operates normally in the test mode, the program in the control unit 00668461 for the wash cycles may have been corrupted.