The dishwasher goes through a complete cycle and counts down to 1 minute but wont click to 0 but continues to just run with water remaining in the bottom. One time I pressed the Power button, it stopped and went back to 14 minutes and then completed the cycle to completion. We usually use the normal wash button. I used the Eco cycle and it repeated the same problem. All the pumps and cycles seem to work fine.
Answer Hello Garet,
This is normally caused by one of two things. Either there is a drain issue and the unit cannot completely drain the water out in the allotted time or the control has a programming glitch in the EEPROM and the control will have to be repaired. Remove the filters and the single screw holding the impeller cover in place and use a wet vacuum to make sure no glass shards are present in the impeller area. If this is clear, the control is the most likely cause of the issue.