How is the control unit taken out?
Answer Hello Ron. Disconnect the power to the unit. 1.Remove fascia panel by removing six (6)T-20 Torx inner door screws.2.Disconnect wire harnesses from module 647475 after noting connector locations. 3.Remove fascia panel from console by removing four (4) T-20 Torx screws.4.Remove two (2) T-20 Torx screws holding module to console.5.Carefully pry back locking tabs on each front corner of module, then remove module from console. Remove button pad from module.
My dishwasher will run normal, until it gets to last one min, then will stay running and will not go into last cycle.
Answer Hell Ron. It sounds like the control may be bad, but first check and see if there is any water in the bottom pan causing the unit to go into drain mode. If there is water there, you will need to look and see where the unit is leaking from. Hope this helps.