My dishwasher will not fill with water. If I fill it with the Sink it runs fine until the water is gone. I replaced the inlet valve.
Answer Hello Jeff. Check and make sure the float is not stuck up in the unit. If the float is good and working properly, and there is no power coming to the water valve, you will need to replace the control module in the unit.
WON'T FILL. REPLACED THE WATER VALVE ASSEMBLY. WANT TO CHECK THE FLOAT. IS IT UNDER THE FLOOR OF THE DISHWASHER?
Answer Mike, Yes you will need to remove the kick plate and check the float switch shaft 00263122 float switch lever 00263123 and switch 00165256 or the Level Switch Assembly - Water level regulator 00263185 Thanks and Good Luck