Part #00069796 replaced part #175711, the new part has three terminal which terminal do I use and what do I do with the extra terminal?
Answer Hello Mark. Look at the terminals on the old switch. You will see NC, NO, or COM. You will match the old with the new on the switch.
Our machine will only run for about 2 minutes. It sounds like the pump is on. When we should start getting water, we have the finished beep and the machine shuts off.
Answer Hello Ken,
These units have a flood switch made under the unit in the base assembly. If water down there raises the float even by a hair, the unit will drain the water out and will not complete the washing cycle. The most common cause or the issue is the water inlet valve not fully opening, which causes a dribble of water from the fill assembly on the side of the unit. This small dribble accumulates in the main base and generates the issue.