My dryer wont heat, everything else works fine (drum, light, blower) Possibly heating element but cant figure out where its located and dont wanna disassemble the entire unit. Can you advise or send a diagram? Also would it show the thermal switch as well?
Answer Randy, Here's some help "To remove electric heater:•Turn off or disconnect electric power.•After removing rear panel screws & one rear duct screw, remove rear panel.•Remove four rear cover screws & two duct screws, then lift rear cover with duct up and away from heater assembly. Disconnect wires.•Slide heater toward rear of dryer until tabs slide out of slots in dryer base." You'll have access to test the heater, hi limit and thermal fuse for circuits and damage. Thanks