Mid way through wash cycle the washer stops @ door unlocks?
Answer Hi. Remove the top. Find the supplied tech sheet inside the unit folded in a packet. This allows you to put the unit into a diagnostic mode. The machine self test each component one by one. If a fault code is found then it will pop it up. This allows the circuit and all devices to be tested as explained in the charts. Use a volt/ohm meter part # TJMA-DM1 to assist you in your diagnostics. If the incomming water is too hot then it may over pressurize the cold tub and pop the front door loose. This is extremely rare. I suspect that maybe the unit is not level front to back and side to side and is cocking making the weak door latch part # 00497255 to pop open. Thank You.