My Thremador main oven fails to fire up in bake and convection bake mode. The top burners, auxiliary oven, main oven broiler work. The PC board was replaced 1.5 years ago. The oven igniter (AP319444) was replaced 3 days ago. There still no spark to the main oven, and there is gas smell upon turning on the bake/conv bake selection. I need help to fix this problem, my questions are:
1- Would this module (AP2825253) support all re-ignition of the oven or just for the top burners alone?
2- Should I reset the oven?
Answer Tanner, here are some checks you need to make for a no bake, ignition issue : "NO BAKE 1. Check incoming line voltage to the DBL (double line relay) NO side and neutral. Should have 120 VAC. If no voltage present trace wiring back to terminal block. 2. Program the unit into Bake or Broil. Check voltage at the DBL (double line relay) com side to neutral. Should read 120 VAC. If no voltage present replace main relay board. If voltage is present then check if cooling fan is running. If cooling fan is not running check wiring and cooling fan motor. If cooling fan is running then check the air switch/sail switch that is mounted to the cooling fan assy. You must remove cooling fan to gain access to air switch/sail switch. **Note: The cooling fan should turn on immediately when any cooking cycle is programmed." If all checks OK, replace the oven igniter device 00618624 Good Luck and Thanks