I have the part. I need instructions on how to install the on/off switch. Where can I get the instructions?
Answer Hello Gregg. Here are the instructions from the manufacture for the module. This will get you access to replace the On & Off switch 175338. Hope this helps.
1.Remove fascia panel by removing six (6)T-20 Torx inner door screws.2.Disconnect wire harnesses from module after noting connector locations. 3.Remove fascia panel from console by removing four (4) T-20 Torx screws.4.Remove two (2) T-20 Torx screws holding module to console.5.Carefully pry back locking tabs on each front corner of module, then remove module from console. Remove button pad from module.