Water Inlet Valve

Yvette for Model Number bosch 6508

Answer Hello Yvette. Here are the manufacture instructions. Hope this helps. Disassembly To remove water valve: Tools needed: T20 Torx screwdriver & pliers. 1.Remove two (2) T-20 Torx screws from toe kick and tilt toe kick out from under dishwasher. 2.Remove base insulation (on models with insulation). 3.Move sump inlet hose away from water valve (without disconnecting it). 4.Disconnect wires from water valve, including ground wire. 5.Remove two (2) T-20 Torx screws from water valve. 6.Pull valve out from dishwasher and disconnect water hose from rear of valve. Remove any water from sump & base. 

1 person found this answer helpful.

Guest

Answer Hello. If there is no water coming to the machine, this could cause that problem. You can test to see if there is power coming to the valve. If there is power there, but no water, then you will need to replace the valve. Hope this helps. 

1 person found this answer helpful.

Laura for Model Number SHX57C05UC Bosch dishwasher

Answer Hello Laura. No, if the unit does not drain, and the hoses are not clogged, you will need to order and replace the drain pump on the unit. 

Mike for Model Number Bosch DishWasher # SHX43C05UC/46

Answer Hello Mike. I would suggest taking the water line off the dishwasher and then turn on the water and see if water flows from the water line. If not, the line is either not connected or clogged. 

Brent for Model Number Bosch Dishwasher SHU5315UC-12

Answer Brent, The water flowing into the unit when unit is off does sound like it is a water valve issue. With the unit being on 2hr and not advancing sounds like a water heating issue. You will want to check the heater and thermostats to make sure that they are good. Also check the wiring from the heater up to the control board, especially where it goes into the door for broken or damaged wires. 

Tim for Model Number Bosch Dishwasher SHU9915UC/U11

Answer Tim, The water inlet valve for your unit is part number 425458.