24/7 Customer Support

CHECKOUT
Items in Cart:
Total
$0.00
HELPING DO-IT YOURSELFERS SINCE 1999

Noise when spin stopped

William M. • Huntington Woods, MI • April 01, 2014
My Repair & Advice

Replaced dampening straps. Did all 4 as 2 were broken and figure the other 2 (there are 4) would soon. Easy after you get the top off of the washer. Just held by 2 screws. Why there are 2 different hex head screws rather then there all being the same I don't know, so you need 2 different wrenches to remove the strap. Other then that went well. They were smart enough to make the hard to reach screws that fasten to the washer frame captive so you do not have them falling into the base of the machine like I was afraid would happen. I think it took 1 hour to take apart, replace the straps and put covers back on. Now quiet as new when stopping., --bill

Do-It-Yourself Story
4 People found this story helpful
Do-It-Yourself Rating
  • 1
  • 2
  • 3
  • 4
  • 5
Easy Difficult
Repair Time Estimate

30-60 minutes

Tools Used
    Nut Drivers, Screwdrivers, Socket Set
We are Safe, Secure, Dependable and Trusted
  • BizRate.com Customer Certified Site - Click to Verify