The number 82 shows on display when trying to start a load. Then it does nothing. Ideas?
Normally the 82 would indicate length of time that the unit has to run. You will want to check to make sure that there is power getting to the water valve and make sure that the float is not stuck and that the float switch is good.
I just purchased the latch assembly from you and put it in a few minutes ago. It fixed the CL code. Everything shows normal like it is running, but nothing is happening. Is this my board?
Answer Hello Samuel,
If the connections are all on the control tightly, you should make sure the unit is sitting on all four feet. If one foot is off the floor, this can put a warp in the tub that will prevent the door switch from making contact with the door latch. This will prevent the operation of the machine since the unit thinks the door is open.
My dishwasher stop working. None of the buttons do anything, but if u turn the power off then back on pf will show up in the display then does nothing.
Answer Hello Rich,
You will want to check your Membrane switch to make sure that the ribbon cable is seated into the control board good and tight. Also check for corrosion and clean with alcohol. If this checks ok then the membrane switch 154639203 would need to be replaced.