Board

Brent for Model Number 7909422440B

Answer Hello Brent. Usually the code F10 is for runaway temp. If you locate the tech sheet on the unit, it will give you the error codes for the unit. If it is runaway temp, you will need to order and replace the oven sensor in the unit. 

Art for Model Number Ken more 790.9641240a

Answer Hello Art, The surface elements and the bake compartment are both completely separate from the terminal block of the unit. The control board will have nothing to do with the operation of the surface elements. If you have replaced the infinite switches and the elements, the issue has to be either the receptacle the surface elements plug into or the wiring. 

Cathy for Model Number 79096612407

Answer Hello Cathy. If the simmer board 316429301 is bad on the unit, it will prevent the element from working properly. You will need to check and see if the board is bad on the unit. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. Hope this helps. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html 

Rob F. for Model Number Kenmore 790.9421240B

Answer Hi Rob. You need to change the infinite switch because the pilot lamp is geeting its power fgrom it. Part # 316436001. Thank You. 

Brian for Model Number 79096419401

Answer Brian, Before you do anything or repalce any parts, you should check your average oven temperature, you may only need to calibrate the control. First, get an accutate thermometer, you can place in the oven. Pre heat the oven at 400 dgrs. for at least 20 minutes. Then you'll need to listen and write: when the control clicks or notice the temp, start to rise, write down the temperature, when the control clicks or the temp. starts to drop, write down the temp. Do this at least three times. Average the temperatures, the average off temperature should be within 50 dgrs. of the on temperature and the average off temperature, should be within 25 dgrs. of the set temperature. If your averages are within the specifics, your control and temp. sensor are fine. You can recalibrate the control to within 5 dgrs. if needed or desired, without replacing anything. Thanks and Good Luck 

Shawn for Model Number 79094359700

Answer Hello Shawn. Test the bake element 316206000 and make sure it is good. It should read closed for continuity. If so, you will need to replace the clock/timer 316557118. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. Hope this helps. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html