Using upper oven after shutting down in about 15 minutes. I get a warning signal and error code of f-10. I replaced the sensor and was good for about 2 weeks. Could it be the circuit board and which one as I see there are three for this model?
Answer Hello Rich. Runaway temperature.
Oven heats when no cook
cycle is programmed. 1. Check RTD Sensor Probe using the RTD scale found in the tech sheet.
Replace if defective.
2. If oven is overheating dsiconnect power from the range and unplug connector P1 from
power supply board. Reapply power to the range. If oven continues to heat when the power
is reapplied, replace the oven relay board.
3. Replace the EOC.
NOTE: Severe overheating may require the entire oven to be replaced should damage be