Touch pad on control panel is not working. Touch a button and nothing happens. This was just recently installed on 11-12-12. What gives?
Jmp for Model Number PLD4555RFCO
Answer JMP,
You will want to check to make sure that the control panel is not in child lock mode. How to exit would be in owners manual. If this checks ok then you want to check your ribbon harness connection at the control board to make sure that it has a good connection. If the connection is good then it may be a problem with the control board.
There is a flashing clean S on the screen. I tuned off the circt breaker for 30 sconds. A Pr light went on. About a miniute latter the flashing clean s is back on. Time for a repair man?
Charles H for Model Number pld4555rfco
Answer Charles, At this point, no you don't need a service/repairman. The "PF' and the " Clean S" are both normal displays. "The CLEAN indicator is energized at the end of all wash cycles with the exception of a Rinse and hold cycle. The clean indicator will remain on until the door is opened. After the door is open, ALL indicators will be extinguished with the exception of the “Rinse aid low” if applicable. The SANITIZE indicator is shown in the front display as an “S” and will be energized at the end of any cycle that the Santi option has been selected. The
sanitize criteria must be completed correctly for this indicator to come on. This indicator will be extinguished when the door is opened. The PF = Power failure = The control has experienced drop in power to the processor" That would be normal since you turned the power off to the dishwasher. Unless you forgot to mention something, basically all is OK. Thanks and Good Luck