Dishwasher lower orbit spray arm broke off. We still used the dishwasher for a few days after that, but an error code appeared. I ordered an new lower orbital spray arm and installed it. The code still appears. The dishwasher will oprate on the rinse option only. It rinses and drains fine but will not heat. The error code is washing, drying, ER clean S. Is this the keypad ? thx.
Yes, the error code that you have represents a Membrane switch failure. Main Control Board has detected a stuck key or a key pressed
for more than one minute. Check connection from keypad to Main Control Board. If correct, replace keypad. If error still exist, replace Main Control Board. (Note: washing, drying, and clean s may appear in display when error code is present)
I just ordered a new control board for my dishwasher. Does it come with a diagram on how to install the new one? If not where can I find out how to remove the old and install the new.
The control board does not come with a diagram on how to install the new one. In order to replace the control board you would need to turn the power off to the unit, open the dishwasher door and remove the screws around the perimeter of the door. This will allow access to the control panel. You will remove the cover over the control board and transfer one wire at a time to the new control board and reassemble.