Board control has a loose clip and no light on the display and ice and water do not dispense. Two lead wires and one clip on was off on inspection? How is this part installed?
Answer Keith, your first check needs to be at the freezer door hinge, Remove power to the refrigerator and check the dispenser wiring harness to make sure you don't have any loose or damaged connections or wires. All models with a touch selection on the front will have a
electronic control behind the front panel of the dispenser. Two gain access to the control area you will need to pull the
drip tray out first. With the drip tray removed, remove the 3 screws at the bottom of the front panel. Lift up on the front panel, there are tabs on the top of the panel that slide into holes in the door panel. Swing panel out to side, being careful not to pull the wires
out of the disconnect plug or the board itself. Carefully unplug the wiring harness from the touch panel on the front cover. This will give you access to the control board. On models with electronic control to gain access to the control, snap the light socket loose and remove the 6 small screws from the board. Pull board straight out of housing. Disconnect plug on left side of board. Disconnect 4 wires to dispenser actuator switches. With the board removed, you can now visually inspect the three boards, for damage, burn marks etc.