Another up stacking question, I have the top panel and brackets AP2107397, but still it doesn't seem there is an intuitive way to connect the panel to the top. The bracket goes in the back and no latch for the panel to connect to the front.
The unit is attached for stacking purposes in the rear of the unit. Though it would seem that the dryer would need to be attached in the front, the way that the manufacturer has the brackets the unit will not move off the washer even if the washer were to get unbalanced.
hello I have a washer and dryer (CRTF1240ASO) that I want to install side by side. I need the cover and fasteners but I do not know how to separate them. Thanks for your help
This unit that is listed is a washer that would allow the dryer to be on it using a stacking kit. To remove the dryer you would need to remove the screws at the back of the unit holding the brackets in place which hold the dryer. The washer should have a top on it so it would not need any brackets or fasteners.