Burner Assembly-Top

Bob for Model Number fgf379wjca

Answer Hello Bob, The only way to remove the screws are to drill them out. You will want to replace all the screws for the burners which will require total of 12 screws 316069301. Do not drill down into the burner, if you do then you will need to replace the burner. 

Mick for Model Number FGF379WECR

Answer Hello Mick. The cooktop lifts upward on the unit. The new burner head 5303935098 does not comes with 12 screws 316089500, they will need to be ordered separately. 

Bee Jay for Model Number fgf379wecs

Answer BeeJay, The burner heads are attached and supported by the cooktop. You will need to turn off the gas supply, turn off power to the range. Remove, the grates, the burner caps and trim rings on all the burners(label thenm just in case). You'll find three(3) small phillips head screws holding each burner to the cooktop. Once you've removed all 12(twelve) screws, lightly tap down on the burner, to "break it loose from the cooktop. Don't attempt to raise the top, until the burners are loose and free, you'll "snap" the gas supply tubes. Also, the 12 scews, most of those will probably break when you remove them from the cooktop burner base, be prepared. Thanks and Good Luck 

Chris for Model Number fgf379wjca

Answer Hello Chris. The burner assembly 5303935098 comes with the lines and the burner head and the igniter and screws. Hope this helps.