Oven Control Board

Shawn T

Answer Shawn, You will want to check to make sure that the thermal limiters on the unit are not bad. Check at the EOC for voltage between L1 and bake. There should be 120 vac at this point and if not then the EOC is bad. 

Suzette for Model Number FEF365BWG PART # AP3586196

Answer Suzette, " To remove the electronic oven control: 1. Disconnect power from the range. 2. Remove the back panel from the backguard. 3. Disconnect the wires and harness from the control board. 4. Remove the four screws. (One from each corner)". Reverse the procedure and test the control. If you're going to be using the original overlay, you will need to be "extremely" careful removing it from the original control. You may even wish to warm it with a hair dryer to keep it flexible and loosen the adhesive. They have a tendency to wrinkle and roll, and usually don't have a pleasing appearence when installed. 

Angela for Model Number fef365bwe

Answer Hello Angela, F1 Control Failure Shorted keypad. Internal checksum may have corrupted control relay shorted or bad probe. Check probe and probe wiring and replace if bad. Power off for 30 seconds. If fault returns replace the control. 

Isaac

Answer Hello Isaac. Test for power to the clock on the unit. If there is power there, and the clock does not light up, you will need to replace the clock assembly 316207510. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. Hope this helps. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html 

Raciel for Model Number fef365bwf

Answer Hello Raciel. Test for power coming from the clock to the elements. If there is 240 volts to the unit, but none coming out of the clock to the elements, you will need to replace the clock assembly 316207510. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. Hope this helps. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html 

Jb for Model Number fef365bwf

Answer Hi JB. The pictorial breakdown does not show a oven thermostat. So double check and see if you have 240 vac at the terminal block and 120 vac between L-1 and L-2 and neutral. If all the wiring is tight and at the elements also, The clock control needs changed. It is part # 316207510. Thank You.