Dryer has heat, but takes 3 hours to dry.
Answer Hello Erv. It sounds like the venting system is clogged or kinked. You will need to check the vent and clean it out. Be sure and clean the vent pipe and the dryer air duct assembly. If the air flow is not good, the unit will retain moist air causing the clothes not to dry. Try running the unit with the vent unhooked from the back of the dryer and see if the dryer works properly.
Spin cycle on the washer does not work. Washer drains Ok but does not spin. Belt is OK. I took the front off and the motor was hot. Any ideas? Thanks
Answer Howard, Check and make sure the lid is locked 134101800 if the lid lock switch does not have a closed(locked) circuit, the washer will not spin. You'll also need to check the water level switch 134493500 and air tube that connects to it. The water level switch, has to reset to the empty position for the washer to spin, if the air tube is clogged with debris, or the switch is faulty, it won't spin. If all's OK and the washer does fill agitate and drain, then the isuue would be in the timer131788300.
SIGNAL BEEPER GOES OFF DURING CYCLE AND WHEN UNIT IS OFF
Answer Ronny, It's not likely that the moisture sensor control board is causing the issue. Could you please repost your question with a proper model and serial number, so we can asist you properly and efficiently. Thanks