The display will flash and beep and most times will not start a cycle. When it does start a rare cycle the display will shut off and restart where it left off. Is this a control panel issue?
Answer Hello James,
This unit has a self diagnostic mode that must be used to pull the fault codes. This is the fastest, most effective way to locate the issue without throwing parts at the machine. The procedure is laid out in the tech sheet normally found in a brown envelope in the base of the unit. If you cannot locate it, re-post your question with an e-mail address and we can send you a copy of the procedure. I'm sorry, but the illustrations and complete procedure with the error code chart cannot be posted in this format.
I have a front load washer, starts but will not go to next cycle . If I change cycle it start and then turn off, do you think is the control electric?
Answer Hi. In order to look up all the research needed to answer the question, we will ned the model #. If you have a email address we can help as well. Remove the top. Find the supplied tech sheet inside the unit folded in a packet. This allows you to put the unit into a diagnostic mode. The machine self test each component one by one. If a fault code is found then it will pop it up. This allows the circuit and all devices to be tested as explained in the charts. Use a volt/ohm meter part # TJMA-DM1 to assist you in your diagnostics. Thank You.